Atlas Copco Wagon Drill
Atlas Copco wagon drill parts are the replacement components for surface blast-hole drilling rigs. Vikay supplies new aftermarket parts from India for the BVB 25, AirROC T25 and AirROC D40, covering both top-hammer and down-the-hole configurations.
Wagon drill wear divides between the drilling end and the chassis. At the drilling end it is the drill steel supports, centralisers, feed chains and rotation components; on the chassis it is the traction, air distribution and control components that dust and vibration eventually take out.
This section covers the Atlas Copco BVB 25 pneumatic rig and the AirROC T25 top-hammer and AirROC D40 down-the-hole rigs. Drill steel supports are supplied in both 32 mm and 38 mm for the pneumatic version, matching the rod sizes in normal use.
Order against the reference number in the rig's spare parts list, or send the rig model, serial number and a photograph of the component. Rigs branded Epiroc are covered by the same parts where the model designation is unchanged.
These are new aftermarket parts; brand names and reference numbers identify fitment only.
FAQS
Which wagon drill models are covered?
- Atlas Copco BVB 25, AirROC T25 and AirROC D40, spanning both top-hammer and down-the-hole rig configurations.
What sizes of drill steel support are available?
- 32 mm and 38 mm for the pneumatic version, matching the rod diameters normally used on these rigs.
Do these fit Epiroc branded rigs?
- Yes, where the model designation is unchanged. The AirROC and BVB designations carried over from Atlas Copco to Epiroc.
